|
BIOS release 1.3 for IS7-G/IS7/IS7-E V1.0
Release information:
[ENGLISH]
New Fixes/Features
1. Added support for IS7-G, IS7, and IS7-E.
2.
Updated CPU micro code (CPU: 0F29H, ID=11H).
3. Added CPU multiplier 8X for
engineering sample CPU and maximum CPU
frequency 412 MHz.
4.
Revised setup menu for OnChip Serial ATA.
5. Fixed on-chip SATA boot issue
while another bootable hard drives
exist and attached to IDE-1
or IDE-2.
6. Updated memory reference code and ICH5 BIOS spec to v1.2.
7.
Fixed PS/2 mouse malfunctioning problem while the USB cable of Media
XP
attached to mainboard.
8. Fixed DOS 6.22 booting failure
from FAT16 partition.
9. Fixed BIOS hang-up problem which is caused by
specific CPU cooling fan
reporting error RPM to BIOS when CPU
FanEQ 60% enabled.
10. Revised the following default settings in BIOS setup
page.
- Bootable Add-in Device: PCI Slot
Device
- CPU FanEQ Active Temperature: 70
C
- CPU Warning Temperature: 85 C
11. Added 80, 85, and
90 degrees C into "Shutdown Temperature".
12. Enabled "IDE Block Mode" and
hided the option.
13. Revised ICH5R RAID BIOS display issue.
14. Revised
power-on delay time from 4~5 seconds to 1~2 seconds after
AC
power lost and resumed.
15. Added description for
"Bootable Add-in Device".
16. Fixed the problem that NB fan still reports
full speed in PC Health
page when "CPU FanEQ Speed
Control" is enabled.
17. Added new option "IDE Bus Master".
18. Added
description for "Shutdown when CPUFAN Fail".
19. Revised the wording of IDE
channels inside the BIOS Setup.
IDE Channel 0, 1, 2, and 3
are changed to 1, 2, 3, and 4.
20. Added new option "SATA RAID ROM" to setup
both "OnBoard SATA" and
"OnChip SATA".
21. Added new
option "HDD Change Message" in Advanced BIOS Features and
the
default setting is "Disabled". If this option is
changed to "Enabled",
the system will show warning message
and prompt for a confirmation when
one or more than one
HDD had been added into or removed from the system.
22. Fixed "CPU
THRM-Throttling" function.
23. Added new options "Refresh Cycle Time", "Read
Delay Adjust (tRD Adj)",
and "Command Per Clock
(CPC)".
24. Changed the default setting of "Drive A" from "None" to "1.44M"
after
Load Fail-safe Defaults.
25. Changed the default
setting of "OnCip Serial ATA" to "Auto".
26. Added "Game Accelerator"
technology.
27. Revised the error reading of fan speed for specific CPU
cooling fan when
FanEQ 60% enabled.
28. Fixed the slow
detection problem when HDD simulation card installed.
29. Fixed the problem
that SMARTDRV.EXE malfunction in DOS 6.22 environment.
30. Fixed the problem
that Windows 98 bootable floppy disk causes system
hang up
during loading CD-ROM driver when "OnChip Serial ATA" is set
to
"Auto" or "Enhanced Mode".
31. Removed the option
"Force Update ESCD".
32. BIOS Compile Date: 6/10/2003.
|
