|
ː지금 얻은 정보이지만 아직 구체적으로 적용된 사진이나 사용기는 없지만
ː해외사이트 게시판에서 읽은 내용을 적어볼려구요 밑에 글이 원문입니다..
ː
ːOK, here we go. To do the voltage mod on the AK-31 you need to go to Radio Shack, and pick up a 47K variable resistor/potentiometer. While your there, get one of these: http://www.radioshack.com/product.a...5Fid=910%2D0228
ː
ːTurn your puter off, and unplug it!
ː
ːConnect the center (of three) terminal on the potentiometer to a wire you have soldered onto the IC Clip you purchased above. Connect one of the outer terminals of the pot to a wire that you have soldered a terminal connector that is suitable to fit under one of your mobo's mounting screws. Get your ohm meter connected to your wires, and turn the potentiometer in the direction that gets you the MAXIMUM resistance. REMEMBER the directions you need to turn it for max/min. Connect the wire with the terminal connector to the mobo mounting screw on the upper left hand corner of your mobo. Connect the IC Clip to leg #7of the "HIP6301CB" Voltage controller IC. It's the one next to the upper left corner of the processor socket. See the attached picture for the correct leg.
ː
ːBoot your machine up into the Voltage/Frequency screen in your bios. Now while watching the voltage monitor, slowly turn the pot in the direction to LOWER the resistance. You will see the voltage rise. I have mine set to 2.2 as maximum. You can now use the bios to LOWER the voltage if you like.
ː
ːGood luck with your new found POWER!
ː
ːOf course, I hold no responsibility for smoke, fire, or electrocution!
ː
ːMy best,
ː
ːDoctor
ː
ːDoctor has attached this image:
ː
ː예전부터 사용해오던 방법대로 저항을 이용해서 한다는데
ː저도 도전해보고싶지만 납땜에는 소질이 없어서 담에 친구놈 불러다
ː시켜야겠네여..
ː근데 개조하시면 A/S 못받거는 아시죠.
ː
ː
|
