|
[ 정보 ] INTEL D850MD 메인보드 BIOS ( 버전 : MV850.10A.86A.0008.P03 )
2001.09.27 일자 INTEL D850MD 메인보드 BIOS 입니다.
변경된 사항은
Features/Errata Fixed in This Release
P03-0008
· Fixed the issue in which the BIOS incorrectly reports that the board can wake via USB from S4 (this is
not possible).
· Fixed the issue of the RPG Boards that always forces the setup question to S1.
· Changed banner to P03-0007.
· Adding new SMM code and I/O APIC support.
· Added AMI BBS 3.1.
· Added ITK support.
· Added processor support
· Allow CTRL, ALT, and SHIFT key states to be preserved throughout POST, so that shift states will be
available to the OS for Safe Mode entry, bypass startup files.
· Fixed yellow bang in device manager when PS/2 devices were missing.
· Fixed a problem where pressing F10 while in Setup caused "Entering Setup..." to appear on the bottom
of the screen.
· Fix a potential issue where the boot sequence will take longer since the boot data are not correctly
initialized.
· Added setting of bit1 SMBIOS BIOS Characteristics Extension Byte2 to indicate BIOS support for
function key-initiated network service boot.
· Fixed problem where some programs were detecting some types of IntelR PentiumR 4 processors as
Intel CeleronR processors.
· Added WFM 2.0 Remote Lockout support.
· Added support to boot from network directly if F12 Key is pressed during POST.
· Updated to rev1.5 of the 82850 memory reference code.
· Fixed issue where pressing keys during Option ROM scan hangs the system.
· Fixed issue where the system was always reporting 80-conductor IDE cable type (regardless of actual
cable type) when certain ATAPI devices were connected as the slave device on an IDE channel.
· When loading custom defaults, the boot order would not always be restored correctly.
· Fixed issue where ATAPI Removable Devices that support UDMA modes were not getting
programmed for UDMA mode.
· Fixed issue with a tape backup unit not being seen in Windows 2000 when set as a master and a HDD is
set as a slave on the same channel.
· Fixed the problem where Custom CMOS defaults cannot be copied correctly to OEM CMOS through
OEM CMOS int 15h function.
· Fixed an issue where the Fault Tolerant Boot Block Test would fail and not be able to boot if ECC was
enabled during the test.
· Fixed issue where manufacturing default was incorrect when a CDROM was not installed in the system.
· Implemented the release of IRQ 12 when the PS/2 mouse is not installed in the system.
· Fixed issue where system could not transition from S3 to S4 in Microsoft* Windows* operating
systems using the timed Power Options.
·
출처 : Intel
|
